ColorBond ^TM is a revolutionary molecular bonding paint that penetrates deep into plastic, vinyl and leather.
The easiest way to restore or change the color of leather, carpet, plastics or metal in automobiles, trucks, cars, boats, or motorcycles.

Toll Free: (877) 882-6567

About BrynDana International Ltd.

• COLORBOND penetrates the surface of leather, vinyl, ABS, PVC, polycarbonate, polyurethane, lexan, thermal plastic urethane, metal, and (TPO) polypropylene, and forms a molecular bond that restores or changes the color permanently.
   
• COLORBOND is dry to the touch in 45 seconds and bonds within 10 minutes. The vehicle can be used within minutes of application.
   
• COLORBOND will not crack, flake, or peel.
   
• The grain simulation is never altered or hidden, no matter how many times COLORBOND is applied.
   
• The suppleness or "hand" is never affected and does not become stiff or brittle.
   
• A base and tinting system is available so an OEM color match is achieved each and every time.
   
• COLORBOND is easy to use. In many cases COLORBOND is a one step process.
   
• COLORBOND is UV stable.
   
• COLORBOND can be used on dash panels, seats, instrument panels, steering wheels, airbag covers, convertible tops, mirrors, and exterior trim. Virtually any where on a car or boat.
   
• COLORBOND is OEM approved and used by The Ford Motor Company.

  Application Tips:
 
       You can apply COLORBOND to most materials in 2 to 4 easy steps. See the chart below for instructions for most materials.
       (Each can of COLORBOND Leather & Vinyl Plastic Refinisher covers approximately 4 square feet)

MATERIAL	Step 1 Buff lightly with 1,500 wet dry sandpaper	Step 2 Clean with Acetone	Step 3 Using ColorBond Adhesion Promoter apply mist coat then apply heat at 140 F for 10 minutes	Step 4 Apply 3 mist coats of ColorBond
LEATHER
VINYL
ABS
POLYCARBONATE
PVC
LEXAN
THERMAL PLASTIC URETHANE
ACRYLIC
FIBERGLASS
TPO
METAL
MATERIAL	Step 1 Buff lightly with 1,500 wet dry sandpaper	Step 2 Clean with Acetone	Step 3 Using ColorBond Adhesion Promoter apply mist coat then apply heat at 140 F for 10 minutes	Step 4 Apply 3 mist coats of ColorBond